Use a foam roller to paint beadboard paneling. A paint roller only applies paint to the surface of the beadboard, leaving the grooves unpainted, which results in a streaked effect. Care must be taken to paint the interior of these grooves and give the beadboard paneling a uniform coat of paint.

What kind of paint do you use on beadboard?

Choose interior enamel paint (often labeled as “door & trim” paint). It will dry to a harder finish than standard latex paint and is more durable against scuffs or scrapes, especially in high-traffic areas.

Is beadboard hard to paint?

It can be a real paint to Paint Beadboard because of all the nooks and crannies. I used to start out by painting the grooves with a brush and then using a roller to get the rest of the panel. But it takes a long time to brush EVERY SINGLE groove on a 4×8 Beadboard Panel so I took out a step.

Do you have to sand beadboard before painting?

Sand the surface with fine-grit sandpaper to remove the sheen. Pre-painted beadboard typically has a high sheen, which may cause problems with adhesion of the new paint. By sanding this to a dull finish, you give the new paint a better surface to adhere to.

Can you roll bead board?

If you were painting beadboard before installation, it would be relatively easy to do the job with just a roller. You could load the roller liberally with paint, then roll it on with enough pressure to squish paint into the crevices.

Should I sand beadboard before painting?

How do I make my beadboard smooth?

The flat face of the beadboard can be sanded with a fine grit sanding block or using an orbital sander. Either way, use gentle pressure and only take off a little at a time so you don’t remove too much putty and reveal the seam.

What’s the best way to paint beadboard?

Apply a quality latex or oil-based paint to the grooves of the beadboard with a narrow paint brush. Work in sections of about 2 feet wide. Paint in up and down motions for vertical grooves and a back and forth motion for horizontal grooves. Use the paint sparingly and don’t overfill the groove.

How do you seal beadboard seams?

Caulk is applied to fill the gaps and seal the seams between the beadboard, the chair rail and the wall. Caulking prepares the surface for painting and leaves clean lines. Clean the surfaces to be caulked. Use a mild soap and a wet rag to wipe the tops of the chair rail and along the seams of the beadboard.

What color to paint beadboard?

When purchased in its natural wood or pre-primed states, beadboard can be painted in the color of your choice. White beadboard is a common sight in traditional vacation or beach cottages, but soothing greens, blues and yellows can also work well to create a welcoming cottage feel in your bathroom.

Can beadboard be painted?

If your beadboard paneling is pre-painted, then it may have a sheen that must be removed so that a new coat of paint will adhere properly. In addition, care must be taken when painting to ensure you cover not only the flat beadboard panels, but also the grooves.

Can you paint beadboard?

Use a narrow paint brush to apply primer to all grooves in the paneling as well. If you’re painting MDF beadboard, an oil-based primer is recommended because the wood fibers may absorb the water in latex paint, causing the beadboard to swell.