Start with the ignition completely off, then turn the ignition to the “ON” position. Do not start the engine. Slowly press the accelerator pedal all the way down 3 times within a 5 second interval. The “Change Engine Oil” message should flash 3 times and clear.

How do you reset the change oil light on a 2004 Chevy Impala?

To reset the 2004 Chevy impala oil light you will need to put the engine in the run position without starting the engine, press the gas pedal to the floor 3 times within 5 seconds, and then the change oil light will flash and then you can restart the vehicle.

How do you reset the change oil light on a 2003 Monte Carlo?

How To Reset Oil Change Light On Chevy Monte Carlo (2000-2007)

1. First, put the key in and turn it all the way to the right in the accessory position.
2. Then you pump the GAS pedal three times to the floor.
3. Once you did that you take the key turn the key back then you start the car and your change engine light has gone away.

How much oil does a 2003 Chevy Impala take?

Capacity: 4.5 quarts (with filter)After refill check oil level.

How do you reset the oil light on a 2000 Chevy Malibu?

OR

1. Turn ignition switch to ON position with engine off.
2. Press the INFO and RESET buttons on the DIC at the same time to enter the personalization menu.
3. Press the INFO button to scroll through the menus until you see “Oil-Life Reset”
4. Press and hold the RESET button until you see “Acknowledged” displayed.

Reset oil service light Chevrolet Impala, using the accelerator pedal. From years: 1999, 2000, 2001, 2002, 2003, 2004, 2005. Turn the ignition to ON, with the engine off. Fully press and release the accelerator pedal slowly three times within five seconds. If the CHANGE ENGINE OIL message flashes, the system is reset.

How do I reset the engine oil life monitor?

There are 2 ways to reset the engine oil life monitor. To reset the engine oil life monitor using the accelerator pedal, go to step 5. To reset the engine oil life monitor using the radio, turn the radio off. Turn ignition to ACC or ON, with the engine off.

How do you reset the oil life on a Toyota Corolla?

Press and hold the SET/RESET button on the DIC for more than five seconds. The oil life will change to 100%. If the CHANGE ENGINE OIL SOON message comes back on when you start your vehicle, the Engine Oil Life System has not reset.

How to perform a change engine oil reset on a Honda Accord?

1 Turn the ignition to ON, with the engine off. 2 Fully press and release the accelerator pedal slowly three times within five seconds. If the CHANGE ENGINE OIL message flashes, the system is reset. 3 However, if it stays on, it did not reset. Repeat the procedure. 4 Turn the key to OFF.